ICD3供电出现ICD3Err0075: Unable to set emulator power.
原厂ICD3,设置供电出现ICD3Err0075: Unable to set emulator power.芯片PIC12F675,想用ICD3烧写程序
MPLAB ICD 3 detected
Connecting to MPLAB ICD 3...
Firmware Suite Version...... 01.26.33
Firmware type......................Midrange
MPLAB ICD 3 Connected.
ICD3Err0045: You must connect to a target device to use
MPLAB ICD 3.
----------set the power by ICD3 3.3---5.0V----------------------
ICD3Err0033: 4 bytes expected, 0 bytes received
ICD3Err0075: Unable to set emulator power.
MPLAB ICD 3 removed---(but the ICD3 is connect with PC!!)
有没有遇到同样问题的,交流一下.
烧写其他芯片如PCD16F887 PIC24FJ256DA210正常. 顶,我也遇到了同样的问题,为解决中 同求解决办法,WIN7系统,XP无问题 {:smile:}路过 有个选项里面是要给出是外部供电,还是由ICD3供电 看看是不是虚焊的问题。 这货不得不说,有时候不太灵,稍微接触不了就连接不上。。。 检查下电源有没有短路 没有在WIN7下用ICD3,在XP下调试烧写dsPIC33F DSC无任何问题。
页:
[1]