刚焊好28035的板子调试出现Failed CPU Reset错误，jtag可以连上
C28xx: Failed CPU Reset: (Error -1137 @ 0x6) Device is held in reset. Take the device out of reset, and retry the operation. (Emulation package 6.0.407.3)C28xx: Trouble Reading Register PC: (Error -1137 @ 0x0) Device is held in reset. Take the device out of reset, and retry the operation. (Emulation package 6.0.407.3)
C28xx: Trouble Reading Register ST1: (Error -1137 @ 0x6) Device is held in reset. Take the device out of reset, and retry the operation. (Emulation package 6.0.407.3)
C28xx: GEL: Error while executing OnReset(1): Target failed to read register ST1
at (ST1&~(0x0100))
at C28x_Mode()
at OnReset(1)
C28xx: Flash Programmer: Warning: The configured device (TMS320F28035), does not match the detected device (). Flash Programming operations could be affected. Please consider modifying your target configuration file.
C28xx: Failed CPU Reset: (Error -1137 @ 0x0) Device is held in reset. Take the device out of reset, and retry the operation. (Emulation package 6.0.407.3)
C28xx: Trouble Reading Register PC: (Error -1137 @ 0x0) Device is held in reset. Take the device out of reset, and retry the operation. (Emulation package 6.0.407.3)
C28xx: Trouble Reading Register ST1: (Error -1137 @ 0x6) Device is held in reset. Take the device out of reset, and retry the operation. (Emulation package 6.0.407.3)
C28xx: GEL: Error while executing OnReset(1): Target failed to read register ST1
at (ST1&~(0x0100))
at C28x_Mode()
at OnReset(1)
C28xx: Trouble Writing Memory Block at 0x0 on Page 0 of Length 0x2: (Error -1137 @ 0x6) Device is held in reset. Take the device out of reset, and retry the operation. (Emulation package 6.0.407.3)
C28xx: File Loader: Verification failed: Target failed to write 0x00000@Program
C28xx: GEL: File: F:\TISOFTPRO\28035\25035_LED\28035_led\Debug\28035_led.out: Load failed.
JATG 连接成功，初学28035 ，不知道咋回事？ 复位脚一直是低电平 ，确认上拉有电阻
自己顶一顶 自己找到原因，5脚接了3.3v 修改后ok 书的那页 发表于 2017-12-15 15:48
自己找到原因，5脚接了3.3v 修改后ok
支持这种有反馈的技术问题帖
页:
[1]