论坛首页 › 马潮AVR › Segment NEAR_Z is too long for segment definition

fangquansx 发表于 2011-3-24 20:10:48

Segment NEAR_Z is too long for segment definition

Error: Segment NEAR_Z (size: 0x34d align: 0) is too long for segment definition. At least 0x8e more bytes needed. The problem occurred while processing the   
segment placement command "-Z(DATA)NEAR_I,NEAR_Z=_..X_SRAM_BASE-_..X_SRAM_END,_..X_EXT_SRAM_BASE:+_..X_EXT_SRAM_SIZE", where at the   
moment of placement the available memory ranges were "DATA:e41-10ff,DATA:10ff--1"
   Reserved ranges relevant to this placement:
   DATA:100-3ff         CSTACK
   DATA:400-47f         RSTACK
   DATA:480-10ff      NEAR_I

使用的是IAR编译器，当我程序中使用较多串口打印函数如UTL_VT_PutString("\n\r Card Temp(C): ")时，就出现这个错误，将CSTACK值变小后，此问题就消失，但是当使用更多UTL_VT_PutString函数时，这个问题又会出现。请问有什么好的解决办法？？？？

fangquansx 发表于 2011-3-25 19:47:06

怎么没有人回答我呢？？？

查看完整版本: Segment NEAR_Z is too long for segment definition