|
发表于 2014-2-27 22:41:34
来自手机
|
显示全部楼层
应该是内存溢出,protuse也有类似问题。
下面是我帮你搜的:
In smaller circuits this error is generally due to a mistake in wiring or connecting components, so this must be checked first.
If the wiring has been validated in the circuit follow these steps:
Select Simulation » Interactive Simulation Settings
Under Initial conditions select Set to zero
Click the OK button
Check to see if the simulation now works. If not:
Select Simulation » Interactive Simulation Settings
Check Set maximum time step (TMAX)
Select Maximum Time Step (TMAX) and change it from 1e-005 to 1e-003
Click the OK button
Check to see if the simulation now works. If not:
Select Simulation » Interactive Simulation Settings
Select the Analysis Options tab
Select the Use Custom Setting radio button and click on the Customize button
Select the Global tab
Check the Relative Error Tolerance [RELTOL] to ON and set it to 0.01
Set Shunt resistance from analog nodes to ground [RSHUNT] to 1e+9
Select the Transient tab
Check Integration Method [METHOD] to ON and set it to Gear
Click the OK button
Click the OK button |
|